Search results

Sorry, I just found the bookmark tab. Thanks

Thanks guys. Lugbolt, it is as similar as it gets. Wolfman, I got your WSM. Thanks. Now I just have to learn how to use it. I'm going through it page by page until I find something about hydraulic line or pto line. Is there a main table of contents or index? Thanks, Randy

What is the best way to replace the PTO pipe on my L3130 HST? I removed the broken one by removing the broken HST filter bracket and filter, 2 pieces of linkage next to the filter, the seat and base and still had to almost straighten the pipe to get it out. It goes over the transmission to the...

Guys, it was harder than I thought. The bevel gear case would not press out. The end of the hollow shaft was flared and would not pass through bearing 80. They had to burn out bearings 80 and 60, take out the bevel gear case and grind off the flare I hammered with what must be the hardest brass...

http://www.orangetractortalks.com/forums/attachment.php?attachmentid=20932&stc=1&d=1http://www.orangetractortalks.com/forums/attachment.php?attachmentid=20933&stc=1&d=1457110863457110863 Billdog, I couldn't get a dremel that far in. I tried a small file but it would be a long time. D2Cat...

Wolfman, I think I see my problem. The bevel gear case needs to be removed before I can access the seal 50, bearing 60, snap ring 70, and bearing 80. I probably flared the end of the hollow shaft of the bevel gear case when I hit it with a brass drift pin trying to get it out. Now it won't pass...

Sorry for the delay. I was on another mission yesterday. The shim and bearing were out. The ring is what I thought was the bearing race. The ends must be hidden behind the groove it sits in. I'll try to turn that ring around until the ends appear. I'll do it today. Thanks.

Wolfman, you are correct. I got the external ring off the hollow shaft. The bearing above is sitting on a ledge and must go up. The hollow shaft won't go through the bearing and I cant see split ring 70.

Thanks, Wolfman. I did remove that snapring. It was an external one around the tube that I'm fighting. I guess I'll keep thumping it back and forth. Now I just have to find a dead blow 10Lb maul. I'll let you know what happens.

Rentthis, thanks, but I'm talking about another part. Sorry I wasn't clear. North Idaho Wolfman, the front axle case is where I am. Part no 20/front axle case and fig 145/bevel gear case are stuck together with parts 050/seal and 060 bearing still in there. I can pry them apart with screwdrivers...

I have a bad leak between my front wheel drive bevel gear case and front gear case. I have removed everything and cannot separate the bevel gear case from the front gear case. It seems the bevel gear case tube extends into the front gear case where a bearing is on the tube. They start to...