Search results

  1. J

    front axle leak

    My 2006 BX1850DX has an increasing leak at center front axle where it attaches to tractor frame. From a diagram I see a seal assembly fore and aft. From that I see a fill plug for adding fluid. My question: is that front assembly independently lubricated and not connected to main...
  2. J

    How many hours on your tractor.

    Bought my 2006 BX18 in 2010 with 420 hrs. Now at 680 hrs. Used for lawn mowing, tilling garden, moving trailers around my yard. Only issues have been front tie rod grease seals, replaced leaking front tires, but now a leaking oil plug which I will correct in my annual fluid change. Very fuel...
  3. J

    hello again. someone tell me where this hydraulic fluid is coming from. this is my '06 BX...

    hello again. someone tell me where this hydraulic fluid is coming from. this is my '06 BX kubota. imagine looking front to rear behind the front center axle assembly in front of the retaining bolt. looking at a schematic break down of the front axle it APPEARS the leak is from the area of...
  4. J

    hello. I realize I have a "stuck" draft/lift regulating knob on my BX. How would I repair so...

    hello. I realize I have a "stuck" draft/lift regulating knob on my BX. How would I repair so the knob will rotate (fast or slow)? thanks.
  5. J

    I realize I have a "stuck" draft/lift knob on my BX. (won't rotate either direction). Any...

    I realize I have a "stuck" draft/lift knob on my BX. (won't rotate either direction). Any thoughts on making it serviceable?
  6. J

    BX won't start

    hello CERLAWSON. arrived home from Sunday services and went to the shop and the tractor. All available relays, safety switches, such were checked again.. I did remove and clean all junctions with electric point cleaner before reassembling. Still nothing; I was missing a switch somewhere. I...
  7. J

    BX won't start

    hello Wolfman and thanks. I have eliminated, as I can find them, the switches listed. they appear open when checked with a meter. From reading other sites most want to blame the ignition switch although that doesn't always remedy their problem. As stated, there is less than 4 volts when...
  8. J

    BX won't start

    thanks. cerlawson, that will come in handy.
  9. J

    BX won't start

    For someone more familiar with these tractors..wouldn't start today. 12.65 volt battery, all systems appear fine. turned on key, checked voltage between solenoid wire and starter .79 volts. jumped from starter connector to battery, engine started. What am I looking at (1) bad switch (2) bad...