Search results

hi guys ok i stripped the engine any way pulled the pistons up out of it and pulled up the liner that is leaking , there is 2 o rings that are machined into the block at the bottom , but i found it 2 be quite rusty inside there i think the previous owner was just running it on water only , im...

im going to pull the liner up tomorow guys to see whats the story my only fear is that maybe the block could be badly eroded which would make it difficult for the o ring or if its a copper gasket to seal properly again

thanks for all your help guys im just in the middle of striping it down now i took the head off it this evening , it looks like there is wet liners in it to me ?? would i be lucky enough to pull the pistons up out of it and pull the liners up and is there some kind of copper gasket or o ring...

ok i took the oil pan off the tractor tonight and pressurised the radiator and got underneath the tractor and i can see water droping between the liner and the block right at the bottom of the cylinder nearest the radiator would this mean a cracked block ?

thanks guys i held off stripping it tonight i was driving it for an hour on saturday last and it was going very well i checked the oil and water and they wer perfect then i started it monday for a few minutes and checked it and the water level had droped and of course the oil was milky , this...

Thanks very much for your reply matt im going to start striping the crankcase off it tonight , i wasnt sure if the liners wer wet or not so thanks for that it eliminates that for me any way , the guy that done the head for me pressure tested it so im pretty sure that the head is fine it never...

hi there could any body help me please i have recently done the head gasket in my kubota b6000 i got the head skimmed and pressure tested and fitted a genuine head gasket but now i have noticed thart there is water in the oil again would it be possible that there could be a cracked liner ?id be...

Hi guys im new to this site and im wondering could any one help me please , I have a kubota b6000 the head gasket went on it recently i noticed the usual milky couloured oil so i stripped it and got the head skimmed and all the valves done while i was at it and fitted a new head gasket, torqued...