Search results

I hope you're not relying on the (Old)Farmer's Almanac? This is from the NWS-

What's the application? Would M12 drain plugs work? https://www.buyautosupply.com/products/bas03759-m12-1-75-drain-plug-pilot-point

Your description isn't clear. Is the motor turning over with the starter but not firing? Or is the starter not functioning? "Jump start directly to starter motor, same." Same as what? Same- no response from the starter when power is directly applied to it?

Odds are that you're not going to find a clean 2-conductor arrangement if you cut off that plug. Many times the positive wire is in the center but the ground is just the braided shielding around it. Since it sounds like your electronics skills aren't the greatest, I suggest getting something...

Different hydraulic motors and mounting. The B2784A kit fits these snow blower models-

Watch the video linked in post #2.

This is wholegoods pricing from 2021- today's pricing will be different. Wholegoods is purchased through Kubota sales, not the parts desk.

Here you go- extra wide jaw stubby adjustable wrench. Big enough for the job but short enough to be easily portable/stored on the tractor. https://amzn.com/dp/B08G8SXGRB https://amzn.com/dp/B0107NAZ2M

With the size of wrench you're hoping to buy and how expensive it could be, you're best off buying a cheap digital caliper from Harbor Freight or Amazon first so you can confirm what size you need.

You've already pinpointed the issue- it's the seat switch circuit. Either the seat switch itself is bad or you have a short to ground between the seat switch and the OPC controller. If you want to isolate whether it's the switch itself or not, disconnect the seat switch connector and jumper the...

Not every Alro has a retail store. Here are the outlet locations- https://www.alro.com/locations/locationsmain.aspx?Loc=Alro%20Metals%20Plus

Three 1/4" or 5/16" female quick disconnect crimp terminals?

When moving the stick to the right, you need to go past the detent for more control. If you want even more speed control, you can install inline flow controls on the hoses or cylinders.

I don't agree when it comes to looping the two ports of a cylinder together. Let's say we disconnect both hoses of a cylinder from the system and the pressure of the fluid in both hoses are at 0 psi while it's in the shade on a cool morning. I connect both hoses together. Pressure is still at...

Actually, this sounds like the opposite of a bad resistor. Typically a blower motor resistor pack has high to low resistance for low to high fan speeds. The highest fan speed is usually full battery voltage, no resistor. Edit- found the M8540 WSM. It is what I suspected- for high speed, the...

Maybe this video will give you some ideas

Does the sump pump discharge to daylight and do you have a trail camera? Put a mini paddle wheel in the discharge path and focus the trail camera on the paddle wheel.

How are you getting this number? The fee hasn't been implemented yet.

List of who's visiting from Canada that would need a non-immigrant visa- https://travel.state.gov/content/travel/en/us-visas/tourism-visit/citizens-of-canada-and-bermuda.html Guide for Canadian residents intending to visit the US- https://travel.gc.ca/destinations/united-states#entryexit For a...

Doesn't apply to Canadians who are simply looking to visit the US, only those who need non-immigrant visas. Besides, that's going to take a long while to actually implement. From a travel blogger- The bill calls for the introduction of a new $250 “visa integrity fee,” which is supposed to...