Search results

Apparently not enough experience here. I cannot find the pedal shaft grease fittings for an L3130DT-1 #34359. Am I missing something vital here? Please help.

Yes. The general rule is that if both batteries are 12 Volt you should be OK. I did this just last week and yes, I felt dumb.

Same problem here. Replaced the fuel cutoff soleniod with no improvement. Ended up replacing the timer relay (under the instrument cowl) and that solved the problem. You may try jumping the solenoid directly to the battery through a 15 amp fuse. You'll have to take care on this but it is...

Supposed to rain tonight. Then I'll drag harrow followed by a couple more before and after photos

In reality the "after" photos would appear bad compared to the "before" photos. The soil was dry and the resulting dead dry grass is not as pleasing as the green grass. It looks more like I had gone over it 5x with a drag harrow. My intent was to take out the bumps and small holes that made it...

A couple or our 23 acres were rough graded years ago but still had clumps and small holes. The ground here is dry and hard. I figured that a Harley Rake (aka power rake) would do the trick. I found a 6' version but questioned whether a an L3130 would have the power to "grind" down about an...

I bought the L3130 WSM when I started having the problem. Perhaps in too much of a hurry but did not find a test for the OPC Timer Relay. Also did not find a parts guide for the 5 relays under the dash. Pretty much worked that out using trial and error. If I missed something in the manual...

The OPC was the problem. Replaced it this A.M. and the engine now functions normally. Had I some way to test individual components I could have saved $$ and time lost. I am thankful that I didn't have to go deeper.

Newbie to this forum. Tractor engine has run without even minor problems until two weeks ago then it suddenly quit. It will start and run for anywhere between 3 minutes and 3 seconds. Replaced the fuel stop solenoid without correction. Am in process of replacing the OPC timer. Hopefully my...