Go Back   OrangeTractorTalks - Everything Kubota > Search Forums


Showing results 1 to 25 of 500
Search took 1.06 seconds.
Search: Posts Made By: North Idaho Wolfman
Forum: Service, Repair & Maintenance 16 Hours Ago
Replies: 3
Views: 120
Re: B5100 fuel system

The rack is the control rack in the injection pump.

Tomorrow I'll get you pictures. ;)
Forum: Service, Repair & Maintenance 16 Hours Ago
Replies: 24
Views: 471
Re: How to test B1700 ignition switch

Test light onto the Large terminal, positive power.
Test light onto main wire into switch, positive power.
Test light on any of the outputs relative to key position, positive power.

If your not...
Forum: Service, Repair & Maintenance 17 Hours Ago
Replies: 3
Views: 100
Re: M6060 loses power working

How fresh was your fuel?
How long is is sitting between running and not?
Do you treat your fuel with a biocide?

Besides making sure the fuel is good, and the filters are clean, there really...
Forum: Buy, Sell & Trade 22 Hours Ago
Replies: 15
Views: 1,009
Re: B7100D Parts-parting out tractor

A b7100D will not have the same front axle as a older B7100HSTD, thus he probably doesn't have the part.
Forum: Service, Repair & Maintenance 22 Hours Ago
Replies: 1
Views: 105
Re: 3 point hitch

4 Things affect the height.

1: Physical limitations to height
2: Tire size
3: Adjustment of the location of the three point lift rods, there looks to be 3 positions.
4: Feedback linkage...
Forum: Implements & Attachments 23 Hours Ago
Replies: 13
Views: 400
Re: Land plane

Technically, House 2800sf and the attached garage 1200sf. ;)
so good sized house, BIG garage. :D
Forum: Implements & Attachments 1 Day Ago
Replies: 1
Views: 113
Re: FEL control valve

Done several swaps, it does make them much smother.
I would avoid regen valves, they don't work very well with older hydraulic systems. ;)
Forum: Service, Repair & Maintenance 1 Day Ago
Replies: 4
Views: 137
Re: D1105 question

If your taking the line off, brake parts cleaner, if your leaving it on just air, but never through a valve as you'll blow out the diaphragm.
So basically, you don't really ever do anything to them,...
Forum: Implements & Attachments 1 Day Ago
Replies: 13
Views: 400
Re: Land plane

I use my land plane on dirt all the time, works like a charm, levels out everything nicely when I make ruts with the tractors and bobcat. :D

I leveled my pad for the house build, got it within an...
Forum: Service, Repair & Maintenance 1 Day Ago
Replies: 4
Views: 137
Re: D1105 question

Breather tube to what?
Crankcase?
Forum: Buying Advice, Recommendations & Pricing 1 Day Ago
Replies: 14
Views: 914
Re: 3 pt. quick hitch decisions

Its a extended hook, made for imported QH's, and the Hook is made in the USA. ;)
Forum: Service, Repair & Maintenance 1 Day Ago
Replies: 24
Views: 471
Re: How to test B1700 ignition switch

Let me see if I can clarify things?

There are two signals that the tractor needs to start and run.
Signal 1: Being a signal to the hold side of the fuel stop solenoid constant feed from the red /...
Forum: Tractor Operating 1 Day Ago
Replies: 9
Views: 222
Re: M4500 PTO clutch lever

There is a small ramp up in the PTO grab, but it's fairly quick. ;)
Forum: Tires & Wheels 1 Day Ago
Replies: 4
Views: 218
Re: Mx5200 tire change

I have R4's on the front and R3 loader specials on the back (wide fat and double R1 tread), so it can be done.

If you want to spend the time go to the tire manufactures site and find out the RC...
Forum: Tractor Operating 2 Days Ago
Replies: 8
Views: 353
Re: L3800 lifting 1000lb bales

Loader specs say it will lift it.
Look at the ply / weight rating of the front tires, most turfs are to low of a rating to hold and move that much weight.

One trick is to get a three point bale...
Forum: Service, Repair & Maintenance 2 Days Ago
Replies: 3
Views: 123
Re: B6200E engine oil

Yes T4 is fine and dandy to use.

Normal pump diesel, even off road is fine.
Forum: Tires & Wheels 2 Days Ago
Replies: 2
Views: 84
Re: Kubota B7200 Rear Rim Width

Rim width is 1"-1.5" narrower than the tire that's going on the rim.

So 8"-8.5", will work for your tires.
Forum: Gray Market & Zennoh 2 Days Ago
Replies: 4
Views: 188
Re: B7000 valve cover gasket????

Sorry to hear it didn't fit.
Sounds like there isn't any other engine like that one. :(
Forum: Off Topic 2 Days Ago
Replies: 27
Views: 1,229
Re: Hammer Drop Time!

Thank you very much, I will use it with pride!
Forum: Off Topic 2 Days Ago
Replies: 27
Views: 1,229
Re: Hammer Drop Time!

Sadly I don't get to use that fine feature! :(

I get to read every wonderful snippet that comes across here! :p
Forum: Off Topic 2 Days Ago
Replies: 27
Views: 1,229
Re: Hammer Drop Time!

10,000,000 % agreed! :d
Forum: Service, Repair & Maintenance 4 Days Ago
Replies: 22
Views: 1,152
Re: Rear hazard lights on l185

Sounds like you got a good handle on it! :D
Forum: Service, Repair & Maintenance 4 Days Ago
Replies: 10
Views: 303
Re: Adding 2 spool to B series (B2400) Pic's

The fitting you need is a Male O-ring boss BSPP fitting.
Forum: Service, Repair & Maintenance 4 Days Ago
Replies: 6
Views: 294
Re: B6000 pto speed selector

It's a three speed PTO.
Forum: Service, Repair & Maintenance 4 Days Ago
Replies: 3
Views: 109
Re: L3600 GST shift problems

Check the universal joint, then if it's not that it's a matter of diving in and splitting it. ;)
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -8. The time now is 08:13 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.