Recent content by xcdhracer15

the wiring matches the diagram on page 2 of the attached PDF, it has OPC, neutral, clutch, pto, & seat safety switches

this is the stop solenoid on the machine: 32721-60014 https://www.colemanequip.com/parts/details/KubotaEngineParts/Kubota-Stop-Solenoid/32721-60014/?gclid=Cj0KCQjwoInnBRDDARIsANBVyATOlyrtlYBSQTBf3ECXv7-n-LJerP-hVzqhRCkWY7fwfFB7eeko7PsaAgXSEALw_wcB

i can get the machine serial number and solenoid number when i get home in ~3 hours. where are you finding the multiple diagrams? I have a copy of the 500+ page manual for B21's but the diagram in the manual i have is definitely not correct.

its a 2 wire solenoid, the diagrams are incorrect as noted in many other threads. it grounds through the pump/ chassis. It has 2 red/black wires only connecting to the solenoid

2005 B21 No start. Bought it with a broken rear diff and missing ignition switch last year. Put a new ignition switch in it, turn to on, and jump the starter relay, tractor started right up. I know some of the safety switches were not hooked up at the time I started the tractor ~9 months ago...

Changed the oring on the pump inlet, fixed it!

Started it up this morning after sitting for ~30 hours and everything worked perfectly smooth for 3-5 minutes then back to the same shudder. Rotated ccw, 3pt still shudders. Drained the fluid (very bubbly). Then i changed all the rubber hoses on the suction lines/ cooler today and replaced...

yes factory BF350 Kubota loader, all lines appear to be stock and they do connect to the block where the ps is connected. Also I don't think the loader had ever been off it judging by how the wedge bolts came out.

they are all visibly dry, no apparent leaks. I'm going to change out all the rubber. I did not order the orings for the near the filter.

Just bought a B2150 HST with 4,000 hours on it. Raising the loader or 3pt there is "shudder" or intermittent action. It goes up a couple inches stops, wait 3 seconds goes up again, stops etc. I have changed the fluid, cleaned the screen, replaced the spin on filter. I replaced the o-rings at...

bought a B21 yesterday with ~1300 hours on it with a broken differential. The official wording from dealership was: "Removed the backhoe attachment, removed the seat assembly, removed the fenders to gain access to the transmission top cover. Removed the top cover and found ring gear bolts...

L2850 and woods backhoe for parts, tractor was next to a barn that burnt. bf500 loader Lots of good parts, all surface rust, no structural rust on anything. I'm taking a couple steel hydraulic lines off the loader and the bucket. Everything else is for sale. Make offers, located in Conway NH...