William1's latest activity
-
William1 reacted to Dustball's post in the thread B-26: Is there a 'pigtail' replacement for the ignition switch connector? with
Like.
I just realized that the profile of the switch housing looks a lot alike the connector on my wiper motor. I ordered plugs/terminals for... -
William1 replied to the thread Do you have a vanity plate?.
-
-
William1 replied to the thread LX2610 50hr shop vac question.Nope, I just had the spot on the property. I was comfortable driving up it because it was a sharp angle from the flat (think like a...
-
William1 replied to the thread LX2610 50hr shop vac question.I'd not use the loader unless you could jam/lock it in place. Jack stands no where tall enough., I think my tractor was close to 45...
-
Re parking on an uphill incline, I did wonder about that. Or raising the front end with the loader or jackstands. But how high?
-
William1 replied to the thread LX2610 50hr shop vac question.I changed my filter on a steep incline. No fluid loss, BX25D, filter on the front bottom side of the HST
-
William1 replied to the thread Replace drain plug washers-my manual doesn't mention it.My little guy has metal washers with an integral oring. Tighten to snug, never replace unless the oring is damaged, which near...
-
William1 reacted to Mr. K's post in the thread Should moderators be elected by membership? with Like.
Hey everyone, Mr. K here, sorry I'm late to the party. Will toss my perspective in here - 1/ Appreciate armylifer (and others) speaking...
-
Biscuits. I'd say it's them biscuits.
-
William1 replied to the thread Equipment Auctions ?.I'll have an auction of my crap when I move to the old folks home. I'll get $0.10 on the dollar for actual worth, the auction house...
-
William1 replied to the thread Best way to give tractor a good wash?.Hot engine, GUNK, soak, scrub the thick spots, rinse off.
-
William1 reacted to North Idaho Wolfman's post in the thread Wrist watch connoisseurs, DO NOT read this thread! with Like.
Send it back for repair it's running a day late. 😜 :ROFLMAO::ROFLMAO::ROFLMAO:
-
William1 replied to the thread Should moderators be elected by membership?.I am an admin on a few sites, a moderator on others. Site owners and other moderators are the ones to select a new moderator. Usually...
-
Doing a ground up 100% restoration on my RCK60-24B while in the process of replacing the deck shell. I had replaced the gearbox...
-
William1 replied to the thread Does my ZG327 really need a new engine?.We've been ghosted....
