TheOldHokie's latest activity
-
TheOldHokie replied to the thread Bad Welds?. -
-
Hoses too short is the #1 culprit for pulling out of the hydraulic remote outlets.
-
TheOldHokie replied to the thread M6060 Rear Remote disconnects.If fully coupled excessive hydraulic pressure should not cause a disconnect. Those couplers can handle considerably more than the...
-
TheOldHokie replied to the thread Need advice on replacing Kubota LA723 FEL quick hitch.Common problem - just bend it back. A $0.00 repair. Dan
-
TheOldHokie replied to the thread Hydraulic issues.It is internal - just a poppet valve teed off the pressure side of the pidton. Having seen several reports like yours I think the issue...
-
Messicks Kubota says they have one in stock, so you are not the only one to have the problem.
-
TheOldHokie replied to the thread Lost Lift on Front Hydraulics and rear three point..If you have return flow from the valve when a spool is shifted the pump is supplying oil to the valve. That oil can only come via two...
-
TheOldHokie replied to the thread Hydraulic issues.Thats exactly the scenario Russell is talking about. Hydraulic pressure in that cylinder is holding the rake up and as you move around...
-
TheOldHokie replied to the thread Hydraulic issues.It serms to be a common failure. Some possibilities: Overloaded 3pt Defective safety valve Defective casting Dan
-
TheOldHokie replied to the thread Ping sound and palpable pop on dipper after operating.Off the top of my head the noise is caused by a gradual leakdown of boom and/or dipperstick cylinders. Dan
-
TheOldHokie replied to the thread Looking to hagrid for advice.All pretty successful groups :) Nick Danger, Third Eye - Firesign Theater Tyrone Shoelaces (Basketball Jones) - Cheech and Chong...
-
We'd get Chicago and Boston here in PA after some of the local stations shut down for the day (yes kiddies, they did that). These...
-
TheOldHokie replied to the thread Looking to hagrid for advice.Is your horizon wide enogh to include Nick Danger and Tyrone Shoelaces dancing the Mud Shark 🙄 Dan
-
TheOldHokie reacted to whitetiger's post in the thread Pinhole leak in metal hydraulic line with
Love.
Use a compression fitting and add a short section of hose to repair it. Just use two P clamps around the tubes rather than the c-clamp... -
TheOldHokie replied to the thread Pinhole leak in metal hydraulic line.Exactly!! Dan
