Recent content by Sberti

Well tractor is back and I’ve run it for several hours without issue. Only thing I can think of is maybe there was some corrosion on one of the wires connections. They said they cleaned the connections while they were testing them. So maybe that was the issue? I do not know

UPDATE: Tractor has been with the dealer for 4 weeks now. They haven’t been able to figure out the problem. They did find a resistor on the CAN termination that was somehow unplugged and haven’t been able to duplicate the issue. They’ve tested all the wiring harnesses, sensors, etc, and...

I think we all know what the worst case scenario is.

Kind of where I thought it was going. Don’t think it’s a sensor at this point with the blown fuses. Guess I’ll have to pull the deck and see if there is an obvious short somewhere. May just bring this one to the dealer

This is what I’ve found regarding the codes... U0081 / 523548-2: CAN-KBT frame error Behaviour during malfunction: • Insufficient output Detection item: • CAN-KBT original frame error DTC set preconditions: • Battery voltage is normal • Key switch turn OFF to ON • Starter switch signal...

My MX5800 HST shut down randomly on me and would not restart. Found a blown ECU fuse. Replaced it and got a little more work out of it before it did the same exact thing. Limped her home replacing fuses along the way. I sprayed some fluid film on the speed control pedal. Didn’t help and the...

Ever figure this one out? I’m getting codes U0081, U0082, and U0083 after replacing a blown ECU fuse. Fuse kept blowing and shutting the tractor down as I limped it home to the garage. This is on my MX5800

So i’ve seen a few posts on this topic where folks have had trouble getting the loader into the float detent. All the fixes seem to say to clean the caps and ball bearings on the bottom of the valve. My issue is slightly different. I have no problem getting the stick into the float position...

Thanks for the speedy response. Sounds like theres no way around it then.

Rookie to 3rd function operations here. Got a grapple claw on my loader and MX5800 tractor. I can’t close/open the claw and tilt at the same time. Is this normal, or does it depend on the 3rd function valve capabilities?