Recent content by MWC1314

Yes these are a breakaway coupler. In the past when the hydraulic cylinder hit its limit I could hear the system build pressure but nothing disconnected. Now every time the cylinder hits its limit or it is under a load it disconnects. The hoses are plenty long, and it’s happening when everything...

Thanks, I checked that, but this is happening when the unit is sitting still in my shop.

Yes it is a double action, and only one hose disconnect, it is usually happens when I am extending the cylinder (raising the arm) but it will also happen when I retract the cylinder (lower the arm) and the safety chain is connect to prevent the arm from lowering.

I just have one set, it does it mainly when I operate the lift arm on my bale processor. I agree that it seems like there is excess pressure to the remotes, and it is forcing the fittings to dissconnect. The processor works fine on my larger tractor so it leads me to believe it is something on...

I have a M6060 and the rear hydraulics constantly disconnect when under load. I replaced the push/pull connectors and it continues to do it. I am at a loss as to what to try next, any advice would be greatly appreciated.