Mountainman's latest activity
-
Mountainman replied to the thread New clutch wont release.Had a customer with same issue. Verified everything was correct and adjusted correctly. Ended up being a crack in the clutch fork... -
Mountainman reacted to Runs With Scissors's post in the thread B8200 HST Incline stalling with
Like.
How steep of an incline? And are you pulling anything? The reason I ask, is that recently I was making a "sledding hill" for my... -
Mountainman reacted to North Idaho Wolfman's post in the thread B8200 HST Incline stalling with Like.
This in itself is not that unusual and not necessarily an issue. Could still be a mechanical clutch issue. Very unlikely a HST issue, as...
-
Mountainman replied to the thread B3030 and B2910 - same frame?.If you can find one the bh4974 subframe is made for the b7800 which should also work on the b2910 and works with the bh75 and bh77...
-
Mountainman replied to the thread B1550 Backhoe not working.You cannot put a tee in a pressure line. Fluid will always take the path of least resistance so youll have flow but no pressure. You...
-
Mountainman replied to the thread B7100 HST or B8200 gear for first tractor.B7100hst is considered live pto for the fact that you don't need the clutch to drive the tractor or switch gears. Gear drive version is not
-
Mountainman replied to the thread B8200 HST Incline stalling.If you can put a tiller or cutter on it and put it under load see if it works normal or if it stalls out. That'll help determine whether...
-
Mountainman replied to the thread B7100 HST or B8200 gear for first tractor.B8200 is a lot more tractor than the 7100. But hst is much better for loader work. If your going to do much loader work look for...
-
on stuff like that you sure want to pull the fenders and floors off and inspect everything above VERY well. The main source of leaks is...
-
Thank you North Idaho Wolfman and Mountainman. I appreciate your help. Ordering the parts today - will begin studying the steering...
-
OK it is sorted. I checked the fuse box and nothing blown but pulled the starter solenoid 15amp and it was crusty pins so replaced that...
-
This tractor can be started and run with the dash disconnected and lying on the bench.
-
Mountainman replied to the thread B2110 INSTRUMENT PANEL REMOVAL.You have a valid point. In this case the panel is nothing more than a mechanical tach, couple lights and couple analog guages and short...
-
Mountainman replied to the thread B2110 INSTRUMENT PANEL REMOVAL.Yes it just pops out. Just be easy you don't want to break the bezel around it. Will it stay running if you hold the keyswitch in the...
-
Mountainman reacted to North Idaho Wolfman's post in the thread Kubota B2400 several leaks with Like.
Since the heads are messed up get new plugs and O-rings: (1)qty 6C050-98350 (2)qty 6C050-98400