Recent content by Marknga

That's a lot of rotary cutter! Sent from my SM-G935P using Tapatalk

No I got it from a local dealer who ordered it directly from them. Took a couple of weeks for that shipment to come in.

Spent 7 hours on L4400d with the new J Bar. Working out good so far. Going nice and slow. Some before and afters

Spent 7 hours on the L4400D with the J Bar rotary cutter. Got about 3 acres cleared and the front field cut. Doing a good job. Some before and after.

No this one has 2 but u can add 2 more. Sent from my SM-G935P using Tapatalk

Man I looked at used and folks are crazy proud of them. The ones I found for 700 looked like junk. They may have been serviceable but I dont know. New to this tractor stuff. Sent from my SM-G935P using Tapatalk

Had my new J Bar 5ft HD rotary cutter delivered and was able to clear a little bit. 1st impression was that it was alright. Looking forward to getting busy on the rest of the 11.5 acres.

I have been shopping for a rotary cutter. I bought my 2006 L4400D last fall and it had a Befco finishing mower with it. Our 11.5 acre lot that we will be building on has about acre and half field and the rest is wooded. As I shopped around for rotary cutters I found pricing all over the place...

no sir, didn't see any classic cars.

His wife said that he always wanted a tractor so he bought one. He would start it up and drive it out and put it back in the garage. He would rather use his lawn tractor to cut grass. Almost too good to be true but all his other vehicles are spotless, run great and well maintained. Now I just...

Looking at purchasing my 1st tractor I have no experience at all. Think I found a good deal: 2006 L4400 DT-F with 22 hours on it. Been stored in an A/C garage. Has front end loader and a 6ft finishing mower. $18K Good deal? Anything I need to be concerned with? Tractor runs great. Thanks f...