Recent content by Kenhwy61

I have the same set-up a lx2610 and BH77 and I would agree to let the dealer repair it under warranty. Mine has been back to the dealer twice in 30 hours for leaks in the back hoe control valve body. The dealer was very good about picking the tractor up and quickly getting it repaired and back...

Sorry for the delayed update but I just got my tractor back from the dealer and the problem seems to have been resolved. I had an small oil leak from the back hoe valve body and the dealer picked the tractor up. The told me there was an issue with one of the internal o-rings that caused the leak...

Thanks for the suggestion I will pull the cover take a look.

I usually run at about 2200 rpms when using the hoe. The manual recommends to operate anywhere from 3/4 to full throttle. if someone else has this same setup maybe they would be willing to check the time it takes to extend the dipper all the way out.

I have a new lx 2610 with a BH 77. The dipper speed seems slower than normal. It takes about 10 seconds to extend out. I found a spec sheet that shows on a l2501 the same BH77 should take 4.9 seconds. I had a b2601 with a hoe and I don't remember it being this slow. The other BH motions seem...

This is my take on your situation. I went from a B2601 with a backhoe to a Sany SY16 mini ex and back to a LX2610 backhoe. The mini-ex is far superior for fast digging. My current backhoe 77 seems clunky and slow in comparison although it does get the job done. I used the mini-ex a lot over many...