Recent content by Jasonleek

Yep, the spring was collapsed and the thing bottomed out in the up position. New spring and adjustment on the down limit as well as up limit and it works like new. Thanks guys.

Thanks, I'll check that out. I found a manual for adjusting the height. Hopefully it's just an adjustment.

Thanks, I saw that plug last night has a burnt spot on it, but I was out way past my bed time. I will investigate that this evening and report back. That would actually make sense why things are so weird.

B7510, HST, 4X4, with front end loader

Its right under the dash piece on the RH side, Either 18 or 19 on the diagram. Everything goes dead. I see in the wiring diagram there is no ignition fuse, I guess someone has messed with the wiring as there are several crimp connectors under there.

HST. 4x4. Thanks for the link

It will turn over several times before it blows

When I go to start it. I suspect either the starter solenoid or relay are bad?

The 3 point when raised all the way up it won't go down, the lever wont even push down. If I shut it off an pull the lever up, up, up like 4 times it drops little bit each time, then the down side of the lever works. Also when I shut it off all 4 cylinders leak hyd fluid. They never leaked...

I have to figure this out. Where is the starter located on this tractor? I am hoping to not pull all the panels off if someone knows where the starter is by chance.