Jasonleek's latest activity
-
JJasonleek replied to the thread B7510 3 point sticks up.Yep, the spring was collapsed and the thing bottomed out in the up position. New spring and adjustment on the down limit as well as up...
-
JJasonleek replied to the thread B7510 3 point sticks up.Thanks, I'll check that out. I found a manual for adjusting the height. Hopefully it's just an adjustment.
-
JWhen I got my B7510 it had a belly mower attached. The mower hooked to the 3 point to raise and lower. The mower would not raise or...
-
JJasonleek replied to the thread B7100 Ignition Fuse Blowing Immediately.Thanks, I saw that plug last night has a burnt spot on it, but I was out way past my bed time. I will investigate that this evening and...
-
JJasonleek replied to the thread B7510 3 point sticks up.B7510, HST, 4X4, with front end loader
-
JJasonleek replied to the thread B7100 Ignition Fuse Blowing Immediately.Its right under the dash piece on the RH side, Either 18 or 19 on the diagram. Everything goes dead. I see in the wiring diagram there...
-
JJasonleek replied to the thread B7100 Ignition Fuse Blowing Immediately.HST. 4x4. Thanks for the link
-
JJasonleek replied to the thread B7100 Ignition Fuse Blowing Immediately.It will turn over several times before it blows
-
JJasonleek replied to the thread B7100 Ignition Fuse Blowing Immediately.When I go to start it. I suspect either the starter solenoid or relay are bad?
-
JThe 3 point when raised all the way up it won't go down, the lever wont even push down. If I shut it off an pull the lever up, up, up...
-
JJasonleek posted the thread B7100 Ignition Fuse Blowing Immediately in Service, Repair & Maintenance.I have to figure this out. Where is the starter located on this tractor? I am hoping to not pull all the panels off if someone knows...
