Recent content by Fruitfarmer131

I have both the 7040 and 6040 steering is OK, but both 3 pt won't pick up what they should. Have to believe that it is in the valving, not exactly sure where that is, the remotes are mounted on the rear. I'm also having an issue with the tilt on one of them, it will completely whether...

The loader will lift fine, and tilt the attachment, in this case a set of pallet forks, but the forks, descend, or tip down so apparently there is an internal leak either within the tilt cylinders, or the valve? When we purchased the tractor we got the valving that you could set up so that...

Ours see limited duty, originally it had a cab, and was used for powering an airblast sprayer. Cab fell apart, and was removed, we have a forklift mast mounted on it, needs either a new or rebuilt high pressure injection pump. It starts, runs, but leaks fuel badly. For a 33 yr old...

Maybe I can get some pictures later today, the leak was in the pressure line from the pump to the junction block, believe it was on the upper side, near one of the curves, a slit. I cleaned it up attempted to seal it by welding it with a piece of wire and acetylene torch, then built up a...

Guess I'll have to correct that. We also do have a M5950 on the farm.

Finally got in contact with service at dealership, they didn't know offhand, so thanks. That service manual will come in handy, thanks very much. I did find the leak after removing the rear tire, steel pressure line from pump, had developed a crack. I removed and welded it back up, seems...

Developed a hydraulic leak in a M6040, and couldn't locate where it was coming from other than the right side of the tractor, behind the fender. I drained the fluid, pulled both filters, only the front has a magnet, by the way, and disconnected and inspected two lines from the control, and...

Got a M6040, with an instrument pod that is nonfunctioning, I've checked the fuses as well as a couple under the hood, all appear to be good. Local dealer well not so local can't diagnose the pod itself, but needs the tractor for testing. Does anybody out there have a wiring diagram, or...