Recent content by fox2boost

https://www.messicks.com/parts/kubota/70050-94875

a little progress photo, i got the backhoe partially on but cannot seem to get the mid link bar to line up with any of the supplied holes. i did install the heavy duty bracket. this was with the top link disconnected just to get it out of my driveway for the day. haven't messed with the hydro...

good to know thanks

i just wish i could find the correct one, upon further review my machine puts out 4.8 gpm and the factory pto pump is 5.0 gpm so its not far off.

ill take a few pictures I'm unsure what the difference is with all of it,

ok i will take a picture when i get out of work thank you

do you have anymore detail on where to tap in at the loader valve?

do you know what i would need for a shaft extension if i go the pto route? not much room at all back there..also how do i know if i can go to my factory hydraulics? like where do i tap in?

thanks for all the replies! i have to do some measuring and figure out what my best option is...

yes it does, i would love to see if someone had that aftermarket pump on..

i was looking at this style pump if anyone had any pictures of how they made the mounting hardware, https://factorypure.com/products/vevor-hydraulic-pump-16-6-gpm-540-rpm-2500psi-sae-16-and-sae-12-port-for-log-splitters-or-tractors-new pic for reference of oem pump and mounting, very different..

yes but i assume it has to be solidly mounted, that doesn't sound very easy..

i do not

do you think this is a viable option? will just power be affected or just speed?