Flintknapper's latest activity
-
Flintknapper replied to the thread L2350DT 4x4 Glow Plug Question.That was my conclusion as well and the reason I mentioned it, so it might be used as a diagnostic tool for the OP to determine IF power... -
Flintknapper replied to the thread L2350DT 4x4 Glow Plug Question.On my tractor the key switch operates as such. 1. Off position is straight up (no dash lights, no activation of anything). 2. First...
-
-
Flintknapper replied to the thread L2350DT 4x4 Glow Plug Question.My L2350DT has two lights on the dash that indicate the glow plugs are preheating AND a GP indicator ( a spiral resistive wire) that...
-
-
Flintknapper replied to the thread L2350DT 4x4 Glow Plug Question.GP indicator on mine (same tractor) will visibly heat up (red) in low light in about 20 seconds.
-
Flintknapper replied to the thread L2350DT 4x4 Glow Plug Question.Look to see if your glow plug 'indicator' gets red hot when you hold the key to the left for 30-45 seconds. No relay in that circuit...
-
Flintknapper replied to the thread One Attachment, Six Jobs—Meet the Farm Hand.Not too shabby. Might add a way to store a HaySpear as well. It might fit inside the square tubing and only require a way to 'capture'...
-
-
Flintknapper replied to the thread Running hot water (household hot, not steam) thru a standard pressure washer.Mine is a Generac and it doesn't say you can or can't use warm/hot water in the users manual. BUT it does state the Thermal Relief...
-
Flintknapper replied to the thread Advice for evaluating models of used finish mowers.^^^^^ Not a bad point to consider if a person is right on the 'cusp' with respect to PTO hp. My LandPride 72" mower weighs a hefty 620...
-
Flintknapper replied to the thread Running hot water (household hot, not steam) thru a standard pressure washer.^^^^^^ Yep. Mine even has a Thermal Relief Valve (factory set to 120°F) to avoid seizing the pump. Pump tolerances are extremely tight...
-
-
Flintknapper replied to the thread Advice for evaluating models of used finish mowers.Provided you intend to 'maintain' the lawn and not let grass grow too high, a 60" will certainly work, even a 72" at your PTO...
-
-
Flintknapper replied to the thread Oil filter doesn’t fit.Probably any 3" diameter filter with a M20 x 1.5 thread would work. You'd want the same 'bypass' psi and other features such as...
-
Flintknapper replied to the thread Oil filter doesn’t fit.Original engine?
-
Flintknapper replied to the thread Need help/advice with an L2350.edit Previous incorrect tire dimension.
-
Flintknapper replied to the thread What is the name or part number of this Kubota L2350F part?.Filter is in the side of the trans housing. It is basically just a cylindrical 'Screen'. You'll need it and the O-ring that goes with...
-
-
Flintknapper replied to the thread Need help/advice with an L2350.@hodge wrote: " front's are 7-16's, and the rears are 11.2-24's " ^^^^^ Those were optional size rims/tires and the same as I have on...
-
