Flintknapper's latest activity
-
Flintknapper reacted to North Idaho Wolfman's post in the thread 2011 L45 - Block Heater Port Location with
Like.
The block heater goes into a frost plug location. Just find one that is accessible, usually second one back on the left side of the... -
Flintknapper replied to the thread Is getting a tiller worth it?.My Tractor is only 20 PTO hp and will run a 4' tiller just fine. This is virgin soil, dry, sandy loam and some clay. A single pass...
-
Flintknapper replied to the thread L2550 - Hard starting at all temps.^^^^^ That's what I did. Just added a LED light bar to the ROPS. I have LED headlight bulbs, but even so....they don't provide much...
-
-
Flintknapper replied to the thread LED Bulbs.^^^^^ My experience as well. Don't exceed 13vdc and you should be fine.
-
Flintknapper replied to the thread LED Bulbs.Many LED bulbs are 'polarity sensitive', meaning they will only work with a Negative or Positive Earth (ground), they are specific...
-
Flintknapper replied to the thread Pucker moment.Yowza............! Was the seat of the tractor damaged? ;)
-
Flintknapper replied to the thread Big U-Joint.Hate to have to grease that one. You'd be there awhile.
-
Flintknapper replied to the thread Global warming in SE PA this AM.
-
-
Flintknapper replied to the thread L2550 - Hard starting at all temps.Explanation for that was given back in post #12.
-
Flintknapper replied to the thread L2550 - Hard starting at all temps.I'd replace that indicator and check the connections. I'll have to get my schematic out...but I'm pretty sure the GP circuit runs...
-
Flintknapper replied to the thread L2550 - Hard starting at all temps.^^^^ Its the glow plug indicator. I believe the glow plug circuit runs through. The wire in the indicator heats up and will become red...
-
Flintknapper replied to the thread Post office.They would only send my mail and packages to a different address FASTER.
-
-
Flintknapper replied to the thread L2550 - Hard starting at all temps.Then the mystery is solved. You have a 'Female' Engine. So by default....it will work when it gets damn good and ready and not before...
-
Flintknapper replied to the thread L2550 - Hard starting at all temps.As already stated by NIW (different build of diesel) but please follow that sage advice. Ether is a NO-GO for Kubota Engines.
