Recent content by ewrangler

That helps for sure, I have a wiring diagram for the B3200 and I think I can find the connections. Thanks for that clarification!

Here is a pic of the alt.

Made some progress on the swap. The 2010 flywheel was significantly larger and needed to be swapped to allow clutch mounting. More evidence the 2006 motor was either a gen set or zero-turn. Also the Fan was much larger on the 2006, so I had to use the 2010 smaller fan so it will fit back into...

Thanks Wolfe Man!!!! That helps a lot! I tried to hoist off the motor today, but with the FEL hardware and backhoe BH76 dug into ground (can't remove) the hardware plates are making it very difficult to remove engine from bell housing. I have 1" do go, but grey engine mounting plates won't...

Two main differences I see so far: -----Oil pan------------ 2010 is in shape of a horseshoe viewed from front as the FWD propeller shaft rides in the horseshoe recess. 2006 has a rectangular (flat when viewed from bottom) pan So I'm not sure if the 2006 will Clear the shaft. If not I hope I...

The head gasket was also worn through where #4 interference was happening.

No, never starting fluid, as It always seemed to start with 4-5 sec glow plugs. Here is a pic of the head and the block.

Hey Orange Beings! I've owned a 2010 B3200HST and it has almost 1000hrs on it. For the last 100 hrs, I noticed increased tapping sounds coming from one of the cylinders, and assumed it was due for a valve clearance check/adjustment. I poured a few ounces of Lucas Injector cleaner into tank...