Recent content by eserv

I installed these : https://www.ebay.ca/itm/252113476258? Working great!

It would need to be a TLB model BX. The backhoe won't mount to a regular BX.

They cut through a chainlink fence and dragged it out of the compound some way. We have 6" of fresh snow here covering the evidence.

I wish i knew! they took the sd card out of the security camera

They took the SD card out of my security camera

Some knob stole the Backhoe for my BX24D out of a locked compound here in Hardisty Alberta! If anyone sees a loose BT601 being peddled suspiciously please let me know!

The backhoe for my BX24d was stolen in the last few days! It was inside a locked compound here in Hardisty Alberta. I will get the serial number from Kubota on Monday. Anyone seeing a loose backhoe for a BX being peddled please let me know!

Likely seat switch or wiring to it. Look for broken wires where the cable flexes as the seat moves.

The dry test tells you what the actual compression is. The wet test is to determine if it is the valves or the piston rings causing the low compression. If your numbers are correct your engine won't start. I recommend a leakdown test rather than a wet test because of the danger of damaging the...

So the rings (and probably the pistons and sleeves) are shot

Not a lot to go on, Could be as simple as the three point hitch lever too far back causing a load on the engine while trying to start?

I replaced 3 of them, all on L series tractors and all during cold weather and not plugged in.

I think most of the ecm failures were due to low voltage from the batteries going dead or trying to start the tractor in very cold weather. I use a battery disconnect switch on my 1996 campervan both as a theft deterrent and to keep the battery from discharging during long periods when I'm not...

w

Don't have the solder at the valves, but even if you did the valves never come that close to the pistons ( if the valve timing is right)