Recent content by cjd7514

Thank you. Perfect.

Does anyone have a diagram showing the oder and layout for the hard lines on a 1153. They were all corroded and replacing. I thought I had a good plan for keeping it all organized and marked. Unfortunately the ones I got from Kubota are not exactly thr same bend. Close but a little off...

Ys. Do not disconnect the cylinder

Thank you for your suggestions. I am guessing they caught something with a fork when unrolling hay in the pasture. Likely bending one side down. We couldn't get it back up so bent the other side down to match and it lined up perfect. Thanks for your help.

so talked to the technician at Kubota and he said it is a fairly common problem. their solution is usually to push the low side against a concrete barrier and bend it back. We tried that and it didn't work. so my solution was to put the forks back on, which only picked up the high side. Put...

My wife noticed today that the bucket would not load on the tractor. I looked at it and one of the hydraulic cylinders is 1/2 inch longer than the other. I have measured everywhere and do not see anything out of whack other than that. She said she did not hit anything, just put the forks on...