Recent content by Bigc4

2nd thread since I've joined so let me know if this is not the correct location please. I have searched the internet and this forum and I can only find text stating where the S/N is located on the B2400, but I would like to have a photo. I don't need to see your actual S/N but I would like to...

I heard that the newer design of axle is made as a cast piece as opposed to welded steel, has anyone seen one of these for a B2400?

The original welds are/were all garbage. They looked like earthworms crawling across the tubing. Very little penetration. I've already welded one of them and ground it down, I ground it done because I'm going to make a reinforcement piece out of steel, lay over the weld and weld it in place to...

Here's a picture of the pinion gear with the broken shaft:http://www.orangetractortalks.com/forums/attachment.php?attachmentid=30187&d=1499620483

Here's another picture: http://www.orangetractortalks.com/forums/attachment.php?attachmentid=30165&d=1499569087 The axle housing pivots on the two pins perpendicular to the axle. The pivot on the front is open so axle lubricant is able to leak out. That pivot rests in the front mount that has a...

Here's a picture of the fractured axle housing out of the tractor: http://www.orangetractortalks.com/forums/attachment.php?attachmentid=30164&d=1499568747

I finally made it back to upload some photos, some good news and some bad news. I didn't damage any teeth on the input gear but it did shear off the shaft so same results. I took the whole assembly off of the tractor, took it apart and then re-welded the housing. I found out that there was an...

Hello to everyone, I'm new to this forum and this is my first time posting here so I apologize if this is in the wrong place. I have just recently acquired a 1998 B2400 4wd FEL, it has a belly mower and some other random implements. I mainly bought it to mow my yard, it has some decent hills...